[TOPIC OFFICIEL] tp-link TL-WR902AC Routeur de poche WiFi AC 750 Mbps

[Janacek]

here are the step by step instructions; in essence, the goal is to turn off everything that is not critical to low-noise streaming and then turn off the device's access point features as the last step which makes it a client extension of your home's wifi.

Setup WR902AC:
1. Look at the back of the unit. It should say the name of the device Wifi.
2. Power up the unit using the 5V micro USB. Give it a minute.
3. On a computer select the 2.4Ghz Wifi from the TPLink. Type in the password, this is on the back label on step #1.
4. Once you’re connected, go to http://tplinkwifi.net
(If this step does not work use a fresh browser after deleting the cache)
5. The first time it will force you to set a new admin password.
6. Once you’re in the menu, cancel the quick setup.
7. On the left bar go to the Wireless 5Ghz. Turn off this radio.
8. Go to USB settings. Under Storage Sharing and FTP Server tabs disable both.
9. Go to System Tools, Time Settings, and click on Daylight Savings, Save, Get time from PC, Save. Close the browser.
10. Unplug the power from the TPLink.
11. On the left side of the device move the physical toggle down to CLIENT.
12. Reattach the power. Select the TPLink wifi again and connect.
13. Open the browser again and go back to TPLinkwifi.net
14. Go to Quick Setup. Click Next. Now select CLIENT. Next.
15. There should be a list of your home’s 2.4Gz wifi channels. Select your Wifi with the highest signal strength. On the next screen it will ask for your Wifi password. Click Next, then Next.
16. At the end of the setup it will ask you to click FINISH. Then the device will reset. This will take 2 minutes.
17. At this point the TPLInk Wifi ID will disappear from your computer’s Wifi list. The TPLink is now an extension of your home Wifi. If you connect your computer to the TPLink via LAN it will be an ethernet hotspot (turn off your computer’s Wifi first!). Run a test by opening a browser and you should have normal internet access.
18. You’re all set up! Connect the TPLink to your music server using a dedicated low-noise battery and enjoy! Make sure the battery back is detached from any charging input as that can add noise.