01-13-2017, 03:51 PM
K
Et avec l'alim sotm?
(01-13-2017, 02:16 PM)Roberto a écrit :(01-13-2017, 01:45 PM)Bear a écrit : Bonjour,
La LPS-1 n'est-elle pas un petit peu sous-dimensionnée pour le SOtM sMS-200 ? La tension de sortie max est de 7V alors que le sMS-200 est censé bien fonctionner avec 9V. Je dis une bêtise ou bien ?
D'après mes lectures le Sotm SMS-200 peut fonctionner entre 6,5-14V. La LPS-1 semblerait fonctionner à condition de ne pas mettre un disque dur sur l'entrée USB de l'appareil.
7 V semble être suffisant, toutefois j'ai pu lire que Sbooster conseille la version 12-13V pour le Sotm SMS-200 au lieu de la version 9-10V. L'explication serait celle ci:
Here is Sbooster's response to your question:
The sMS-200 accepts an input voltage of 6.5V – 14V. Based on this specification you can use your 7V – 2A power supply. Please note that the 2A can be insufficient to power the two additional USB ports. This because the offical power consumption is rated at 15W max.
The internal power supply circuit of the sMS-200 is arranged by two or more DC/DC converters. A DC/DC converter runs on Power (Voltage x Current). This means that the DC/DC converter will pull a high current with a low power supply voltage and a low current with a high power supply voltage.
Further there is a relation between the output noise of a DC/DC converter circuit and the power supply voltage. When the power supply voltage goes up, the output noise of the DC/DC converter drops. So in theory when you have an audio device and two power supplies that are identical, but one PSU outputs 6.5V and the other PSU is a couple of volts higher, the later will perform better.
Regards,
Wiebren
Sbooster
Et avec l'alim sotm?
Source Luciano, Diretta Luccia et alim JCAT OPTIMO DUO, Switch Waversa Smarthub.Dac Lampizator Golden Gâte 2
ampli 300B Audio Note Meishu Phono.Enceintes FH en marbre.
ampli 300B Audio Note Meishu Phono.Enceintes FH en marbre.