11-18-2018, 10:48 AM
Salut tout le monde.
Je viens de voir vos réponses que maintenant sorry !
Je n'ai pas encore installé le module par manque de temps, et d'argent, pour l'acquisition d'un bon preamp. A priori soit un M1 soit un mini Hattor. Quand je pourrai.
Pour commander le module, faite un mail à Jos. Il m'a confirmé par mail qu'il était simple de l'installer soi même. Pas besoin de renvoyer le M10 aux pays bas.
A mon avis un bon preamp fera une différence sensible en comparaison de la partie pré du M10 (M10 qui est quand même un excellent intégré pour 1600 en occaz).
Je vous partage la procédure de JOS :
Hello Cedric,
Good to hear!
I don't have any photo but I can describe the steps to take.
Start to unplug the power cable!
1) Remove the top cover of Master 10
2) Look at the display board (the pcb behind the display)
3) You will find the same chip I sent you
4) Take a good picture so you can see how it was mounted (direction is important)
5) Now remove with a little screw driver carefully the chip (by lifting the chip on both sides)
6) Carefully install the new chip. (direction is very important)
If you have questions please sent me a picture of the situation so I can make some marks for you!
Thanks
Jos
Si certains d'entre vous on pu tester l'association Hattor / M10 bypassé je serai très content que vous donniez vos impressions.
J'ai pas demandé à Jos si il fallait mettre le volume à fond sur l'entrée bypassée. Si vous avez l'info à partager !
Je viens de voir vos réponses que maintenant sorry !
Je n'ai pas encore installé le module par manque de temps, et d'argent, pour l'acquisition d'un bon preamp. A priori soit un M1 soit un mini Hattor. Quand je pourrai.
Pour commander le module, faite un mail à Jos. Il m'a confirmé par mail qu'il était simple de l'installer soi même. Pas besoin de renvoyer le M10 aux pays bas.
A mon avis un bon preamp fera une différence sensible en comparaison de la partie pré du M10 (M10 qui est quand même un excellent intégré pour 1600 en occaz).
Je vous partage la procédure de JOS :
Hello Cedric,
Good to hear!
I don't have any photo but I can describe the steps to take.
Start to unplug the power cable!
1) Remove the top cover of Master 10
2) Look at the display board (the pcb behind the display)
3) You will find the same chip I sent you
4) Take a good picture so you can see how it was mounted (direction is important)
5) Now remove with a little screw driver carefully the chip (by lifting the chip on both sides)
6) Carefully install the new chip. (direction is very important)
If you have questions please sent me a picture of the situation so I can make some marks for you!
Thanks
Jos
Si certains d'entre vous on pu tester l'association Hattor / M10 bypassé je serai très content que vous donniez vos impressions.
J'ai pas demandé à Jos si il fallait mettre le volume à fond sur l'entrée bypassée. Si vous avez l'info à partager !